Here is a file I downloaded from the Shark CNC web site. I did not create it and don't remember who I should give credit too. But I assume since he/she shared it there I am OK sharing it here.
I made one for a good neighbor who loves the game. It goes under a lot of different names this file was called fastrack. It is not created for marbles as a lot of them are but I suspect
you can modify it easily. I did by using 3/16" holes for golf tees.
Enjoy. And again thanks to the unknown individual who shared it on the Shark web pages.
I am sharing it as a .crv file so the folk with VCarve and VCarve Pro can use it.
- Fastrack Board.crv
- (455 KiB) Downloaded 102 times
Legacy Arty, Aspire, CCAM