Z Retract Question

This forum is for general discussion about Aspire

Z Retract Question

Postby fredfow3 » Sun May 27, 2018 1:00 am

Hi All,

I recently had to do a very deep (98mm) 3D contouring job, and the tool did a full retract and plunge after each raster pass. It did this in both the roughing and finishing toolpaths. It was a huge time sink, with eighty percent of the machining time being the retracts & plunges, even with a very fast plunge rate. All the limits were set correctly with 2mm clearance all around for rapids and safe Z.

In the future I could manually remove the Z moves in a text editor, but is there a way to keep the tool down close to the workpiece? Am I missing something? It's a pain to edit.

Thanks,

Fred

IMG_2227.jpg
Tube bending block (98mm deep)
fredfow3
Vectric Apprentice
 
Posts: 51
Joined: Thu Aug 04, 2016 1:40 am
Location: Massachusetts
Model of CNC Machine: Laguna Swift 4x4, Shapeoko S3 XL

Return to Aspire - General

Who is online

Users browsing this forum: Mark and 29 guests