Hi I am new to this and I am making a slotcar track but my end mill i 3.00mm and I need the slot to be 3.2mm
I am routing on the line since the sections will not fit together if I route outside og inside the line.
So what is the tip to take an extra 0.1mm from each side at the end?
regards
Keld
making 3.2mm slot with 3.0mm end mill?
-
- Posts: 2
- Joined: Wed Apr 12, 2017 8:14 am
- Model of CNC Machine: home build
-
- Vectric Wizard
- Posts: 1592
- Joined: Sun Sep 16, 2007 2:59 pm
- Model of CNC Machine: Custom DIY
- Location: Lake St Clair, MI, USA
- Contact:
Re: making 3.2mm slot with 3.0mm end mill?
Offset the vectors 0.1 to each side and cut those.
Gerry - http://www.thecncwoodworker.com
-
- Posts: 2
- Joined: Wed Apr 12, 2017 8:14 am
- Model of CNC Machine: home build
Re: making 3.2mm slot with 3.0mm end mill?
Thx Gerry, just found out that it was possible