I need to make a bottom & Lid for some boxes. I need to rabbit a 1/4" on all four sides no problem. I also need to have the bottom & lid gut around the perimeter at a 15° angle this is killing my brain.
I need help figuring this out . I believe that a two rail sweep will work but I cannot figure it out.
I have attached an sample Lid as well as a side view.
Thanks in advance for your help.
Hope this is not to dumb of a question.
Need Help
- CrowsWW
- Vectric Craftsman
- Posts: 155
- Joined: Wed Jun 27, 2012 7:10 pm
- Model of CNC Machine: ShopSabre 4896
- Location: Palmer, Alaska USA
Need Help
- Attachments
-
- Sample Lid.pdf
- (58.08 KiB) Downloaded 97 times
-
- Side View.pdf
- (55.52 KiB) Downloaded 89 times
Troy Crow
Crow's Woodwork's
I have a day job to support my wood habit!
Crow's Woodwork's
I have a day job to support my wood habit!
- FixitMike
- Vectric Wizard
- Posts: 2177
- Joined: Sun Apr 17, 2011 5:21 am
- Model of CNC Machine: Shark Pro Plus (retired)
- Location: Burien, WA USA
Re: Need Help
Easiest is to profile with a 30 degree V bit. You can also use a moulding toolpath, but it will be more difficult, as you will have to extend the cut into a spoilboard. You can also use a fluting toolpath on many short vectors.
Good judgement comes from experience.
Experience comes from bad judgement.
Experience comes from bad judgement.
- CrowsWW
- Vectric Craftsman
- Posts: 155
- Joined: Wed Jun 27, 2012 7:10 pm
- Model of CNC Machine: ShopSabre 4896
- Location: Palmer, Alaska USA
Re: Need Help
duh I did not think of a 30° v bit. I was making to hard. thanks for the advice Mike
Troy Crow
Crow's Woodwork's
I have a day job to support my wood habit!
Crow's Woodwork's
I have a day job to support my wood habit!