Need Help

[CrowsWW]

I need to make a bottom & Lid for some boxes. I need to rabbit a 1/4" on all four sides no problem. I also need to have the bottom & lid gut around the perimeter at a 15° angle this is killing my brain.
I need help figuring this out . I believe that a two rail sweep will work but I cannot figure it out.

I have attached an sample Lid as well as a side view.

Thanks in advance for your help.

Hope this is not to dumb of a question.

[FixitMike]

Easiest is to profile with a 30 degree V bit. You can also use a moulding toolpath, but it will be more difficult, as you will have to extend the cut into a spoilboard. You can also use a fluting toolpath on many short vectors.

[CrowsWW]

duh I did not think of a 30° v bit. I was making to hard. thanks for the advice Mike