Is my preview off?

[mrwoodworks]

Attached is a preview of the large crown I've been working on. Pretty much have it ready to go then I run a preview and get some height difference showing up on the modeling toolpath.
All other toolpaths, the crown, ogee, and angle are done with a molding toolpath, the dental channels are done with a modeling toolpath. I created one model, fine tuned it, then copy and pasted it down my piece. Now it looks like the base heights are wrong, except they aren't! Whats happening?

[Pete Cyr]

looks good except you have 2 extra tool paths that alter the molding but not for the better

[mrwoodworks]

Yeah, I'm only using the first 3 paths in the toolpath tree. The other paths were trial and errors I'm working through.

[matthew.colpitts]

I hate to poach this post with a silly question but can someone please tell me how I post a forum question ? Spent 15 minutes trying to figure it out, sorry and thank you.

[highpockets]

I hate to poach this post with a silly question but can someone please tell me how I post a forum question ? Spent 15 minutes trying to figure it out, sorry and thank you.

Go to the Board Index, pick a section and click the Post New Subject button, top left.