Move to Back?

This forum is for general discussion about Aspire
Post Reply
dcruze
Posts: 13
Joined: Tue Oct 30, 2012 12:04 pm
Model of CNC Machine: Shopbot

Move to Back?

Post by dcruze »

I am working with Aspire 8.5. I am trying to layout different 3d components and use the "move to back" command, but it doesn't work. Has anyone had problems with this?

User avatar
mtylerfl
Vectric Archimage
Posts: 5865
Joined: Thu Jan 29, 2009 3:54 am
Model of CNC Machine: -CarveWright CNC -ShopBot Buddy PRSAlpha
Location: Brunswick, GA

Re: Move to Back?

Post by mtylerfl »

All the models you want to change the 2D grayscale visible order of must be on the same layer for the Move to Back (etc.) function(s) to work.

Once you have them on the same layer, it will work perfectly.
Michael Tyler

facebook.com/carvebuddy

-CarveWright CNC
-ShopBot Buddy PRSAlpha CNC

LittleGreyMan
Vectric Wizard
Posts: 1012
Joined: Fri May 15, 2015 1:10 pm
Model of CNC Machine: 3 axis small size machine
Location: France

Re: Move to Back?

Post by LittleGreyMan »

You can also use layers order to control overlapping of 2D previews. But as "move to back" it will only act on 2D previews.

You mentioned 3d components. These ones are controlled by the component manager.

Read carefully the "Layer Management" and "Component Manager" chapters of the manual.
Best regards

Didier

W7 - Aspire 8.517

dcruze
Posts: 13
Joined: Tue Oct 30, 2012 12:04 pm
Model of CNC Machine: Shopbot

Re: Move to Back?

Post by dcruze »

Thanks for your answers, I tried it and yes that was my issue. I forgot to place things in layers. Thanks so much.

Post Reply