pro70z28 wrote:I got through the project with the stock 3d files in Vcarve Pro, but I think I'll upgrade to Aspire so I can do my own 3d files. The free stock files got the job done this time though. Thanks for the help finding the files.
pro70z28 wrote:Thanks mtylerfl. I have an older version of Aspire V3, but I switched to Vacrve when it was bundled with a new control board a bought awhile back. I didn't miss the change until the foyer project popped up. I'm looking forward to the new version. I did this several years ago with Aspire v2. It's close to life size, cut from big box store 2''x4'x8' foam.
Rcnewcomb wrote:Refer to this thread to read all about the camel project from 2009: The Christmas Camel experiment
Users browsing this forum: No registered users and 35 guests