after years of no problems with Aspire it has now started locking up every time I am using 3 D models. I have emailed Vectric but have no response.
The system gives me a lock up message and than shuts down Aspire. Sometimes the file is saved, but all work is lost back to any prior save I may have done.
IT also tells me that a diagnostic file has been saved and should be sent to Vectric. but I can not find that based on the location described in the message ( see attached photo)
Any help would be appreciated..
aspire looking up
- highpockets
- Vectric Wizard
- Posts: 3667
- Joined: Tue Jan 06, 2015 4:04 pm
- Model of CNC Machine: PDJ Pilot Pro
Re: aspire looking up
Not sure about the error message, but see if this helps locating the dmp file.
John
Maker of Chips
Maker of Chips
- esteeme1
- Vectric Wizard
- Posts: 2132
- Joined: Tue Nov 02, 2010 3:26 pm
- Model of CNC Machine: Cobra 404 ATC; ROMAX WD-1; Shark
- Location: Chesapeake VA
- Contact:
Re: aspire looking up
Check if the correct files are created in the location specified. If not create folder.
Jim Darlas
"Can Do!"
http://www.esteemedwoodcrafts.com/
http://www.esteemedplaques.com/
"Can Do!"
http://www.esteemedwoodcrafts.com/
http://www.esteemedplaques.com/
-
- Vectric Wizard
- Posts: 301
- Joined: Wed Apr 13, 2016 3:38 am
- Model of CNC Machine: Axiom Pro6
- Location: No. Calif.
Re: aspire looking up
Most crashes I've had with other software usually involved the video/graphics card and drivers.
Mark
Pioneer, CA
Pioneer, CA
- Adrian
- Vectric Archimage
- Posts: 14547
- Joined: Thu Nov 23, 2006 2:19 pm
- Model of CNC Machine: ShopBot PRS Alpha 96x48
- Location: Surrey, UK
Re: aspire looking up
Can you attach one of the files that is crashing?
-
- Vectric Staff
- Posts: 338
- Joined: Fri Jun 01, 2012 1:30 pm
- Model of CNC Machine: Various
- Location: Redditch, UK
- Contact:
Re: aspire looking up
Hello Scott,
Could you please e-mail your issue and dump file, along with the steps you took before Aspire crashed to support@vectric.com and hopefully we can come to some conclusion as to what you are seeing.
Thanks in Advance.
Could you please e-mail your issue and dump file, along with the steps you took before Aspire crashed to support@vectric.com and hopefully we can come to some conclusion as to what you are seeing.
Thanks in Advance.
Beki
Senior Application Engineer - Vectric Ltd.
Senior Application Engineer - Vectric Ltd.
- Mark
- Vectric Staff
- Posts: 1054
- Joined: Sat Aug 18, 2007 2:55 pm
- Model of CNC Machine: CNC Shark, ShopBot, Roland PNC3000
- Location: Alcester U.K.
- Contact:
Re: aspire looking up
Hello Scott,
on Friday morning (before you posted this topic).
It might be an idea to check and spam folders for any email accounts that you have.
Cheers,
Mark.
I replied to an email that may have been from you (the email in question originated from a rather strange looking outlook.com email address)I have emailed Vectric but have no response.
on Friday morning (before you posted this topic).
It might be an idea to check and spam folders for any email accounts that you have.
Cheers,
Mark.