Pattern request

[Jane Ndungu]

Happy New Year Vectric family,

Kindly looking for this pattern or ways to do something similar.
Any help is greatly appreciated.

Many thanks in advance
Jane.

[highpockets]

This tutorial will help with the weave pattern. http://support.vectric.com/tutorials/V9 ... ideo_id=67

[4DThinker]

You don't need to model it if you have a veining bit (roundover bit with a sharp tip). Layout the bottom lines of the pattern and do a profile cut ON the line with the veining bit. If I had more time this morning I'd make up a sample.

https://routercutter.co.uk/point-cutting-round-over

[Jane Ndungu]

Thank you for the kind response and ideas. I do not have this kind of bit can i use a ballnose or 90degree V-bit?

Jane

[highpockets]

Not quite there, I missed the little gaps, but you get the idea. This was using the extrude weave.

[4DThinker]

It would be worth it to invest in the veining bit. It will cut much faster than doing it as a 3D model job.

4D

[highpockets]

It would be worth it to invest in the veining bit. It will cut much faster than doing it as a 3D model job.

You nailed it as usual.....

[Fred Grover]

Thanks for the link to that Bit 4DThinker and the file for it. Do you have the exact Router Bit Part # from Whiteside so I can get it here in the USA ? Thanks for what you do here to help others.

Cheers - Fred.

[4DThinker]

Whiteside: https://www.whitesiderouterbits.com/col ... -roundover

They have them with a few different radius dimensions. I don't know what scale you need that pattern made, so you can choose from the selection on that linked page.

4D

[Jane Ndungu]

Thank you so much 4DThinker,
Am definitely going to invest on the bit. thank you.

Kind regards
Jane.