What is the best product to use to fill voids in the pink Xps foam from Home Depot?
Thanks for any suggestions.
Xps foam
-
- Posts: 12
- Joined: Sun Dec 06, 2015 6:28 am
- Model of CNC Machine: home made 5x10
- Rcnewcomb
- Vectric Archimage
- Posts: 5935
- Joined: Fri Nov 04, 2005 5:54 am
- Model of CNC Machine: 24x36 GCnC/WinCNC with ATC
- Location: San Jose, California, USA
- Contact:
Re: Xps foam
- Randall Newcomb
10 fingers in, 10 fingers out, another good day in the shop
10 fingers in, 10 fingers out, another good day in the shop
-
- Posts: 12
- Joined: Sun Dec 06, 2015 6:28 am
- Model of CNC Machine: home made 5x10
Re: Xps foam
Thank you for the suggestions.
- mikeacg
- Vectric Wizard
- Posts: 659
- Joined: Sun Nov 02, 2008 10:53 pm
- Model of CNC Machine: Camaster Stinger, Sidewinder, SB 4x4
- Location: Newberry, MI
- Contact:
Re: Xps foam
I use the foamboard adhesive PL 300 to fill holes. I drill a bigger, round hole and fill it with a foam dowel (easy to make on the drill press). Only need glue in the bottom of the hole and any paint will hide the seams. Plus it sands like it is all one piece. The problem with epoxy type products is that they get hard and sanding is difficult. Spray foam works pretty good and you can build it up in layers but I hate to start a can just for a minor use and end up throwing it away if I don't use it all before it hardens...
Mike
Mike