I am searching for the two rail sweep tutorial and cannot seem to locate.
Thanks Kathy
tutorials
-
- Vectric Craftsman
- Posts: 184
- Joined: Mon Apr 16, 2012 3:14 am
- Model of CNC Machine: Cam Master StingerII
- Location: Tonasket Washington
- Contact:
tutorials
Camaster StingerII - FTC, Vac Table - Aspire
Embroidery - WingsXP
Embroidery - WingsXP
- highpockets
- Vectric Wizard
- Posts: 3667
- Joined: Tue Jan 06, 2015 4:04 pm
- Model of CNC Machine: PDJ Pilot Pro
Re: tutorials
Watch the banner tutorial.
http://support.vectric.com/tutorials/V9 ... ideo_id=19
http://support.vectric.com/tutorials/V9 ... ideo_id=19
John
Maker of Chips
Maker of Chips
- highpockets
- Vectric Wizard
- Posts: 3667
- Joined: Tue Jan 06, 2015 4:04 pm
- Model of CNC Machine: PDJ Pilot Pro
Re: tutorials
Here's a shorter tutorial http://support.vectric.com/tips-and-tri ... ideo_id=18
John
Maker of Chips
Maker of Chips
-
- Vectric Staff
- Posts: 338
- Joined: Fri Jun 01, 2012 1:30 pm
- Model of CNC Machine: Various
- Location: Redditch, UK
- Contact:
Re: tutorials
Hi Kathy,
Here is the two rail sweep guide: http://support.vectric.com/tutorials/V9 ... il%20sweep
Top Tip, in the tutorial browser (http://support.vectric.com/tutorials/V9 ... =1&order=1) you can search for tutorials by typing in key words that you are looking for (see attached image)
Hope this helps!
Here is the two rail sweep guide: http://support.vectric.com/tutorials/V9 ... il%20sweep
Top Tip, in the tutorial browser (http://support.vectric.com/tutorials/V9 ... =1&order=1) you can search for tutorials by typing in key words that you are looking for (see attached image)
Hope this helps!
Beki
Senior Application Engineer - Vectric Ltd.
Senior Application Engineer - Vectric Ltd.