I am new to cnc and learning Aspire is been challenging and addictive. My uncle is a POW and I am trying to make a POW 3d sign for the VFW to raise money for local chapter. I was wanting to make a 3d head tower insert in sign but can't get everything below the surface. Tried to put zero plane in but don't know if done correctly. If I can master the 3d part I can vcarve the letters. Just trying to give back to loved ones and learn Aspire.
Dandy Don wrote:Some of the tower head and wire are still above plane. I have watched 2 or 3 videos on "zero plane". Don't know what I am doing wrong?
Don
Your trying to run before you can walk
I am sure John will help further with this project but once this is done I would seriously consider going back to the very start & working your way up slowly starting with less complex projects
Bit like Maths, don't attempt advanced calculus Until you have learnt to add, subtract multiply & divide
Dandy Don wrote:Some of the tower head and wire are still above plane. I have watched 2 or 3 videos on "zero plane". Don't know what I am doing wrong?
Don
Your trying to run before you can walk
I am sure John will help further with this project but once this is done I would seriously consider going back to the very start & working your way up slowly starting with less complex projects
Bit like Maths, don't attempt advanced calculus Until you have learnt to add, subtract multiply & divide
Martin thank you for reply.
I have been learning Aspire for the better part of 6 months and I know that I am not the expert that you are but I have found that pushing myself is the only way I can learn. If there are online classes that I can take I would LOVE to. This is the only way that I know how to learn is to image it and try to create it.