Strange result with aspire 9.1

This forum is for general discussion about Aspire

Strange result with aspire 9.1

Postby sawmiller » Fri Oct 13, 2017 2:52 pm

Decided to make a mantel, haven't been using 3d.
So I grabbed the soaring eagle in a handcarved recess
And selected it, chose model boundary, and it used the whole face of the mantel..
So I clicked model outline and selected that and finish model, and it dropped down. 39 before carving out the model...
It works as expected in aspire 8.5, so is this a bug?
Haven't tried other models yet, but I'll get back to it later today
Dan
woodmizer sawmill and joe's hybrid cnc, a good combination
In the heart of Tn
User avatar
sawmiller
Vectric Wizard
 
Posts: 428
Joined: Sat May 03, 2008 8:34 pm
Location: camden,tn
Model of CNC Machine: joe's rack and pinion hybrid

Re: Strange result with aspire 9.1

Postby mezalick » Fri Oct 13, 2017 3:54 pm

So, Maybe the mantel was the entire model ???
Next item of selecting just the vector could be that the "model" was positioned .39 below the top surface of the material block ???
Check in the Material Setup at the top right of the Toolpath screen...or as I call it "The Rigth Side ".

Michael
Michael Mezalick
https://carveddetails.com/catalog-book/
mm@mezalick.com
User avatar
mezalick
Vectric Wizard
 
Posts: 2225
Joined: Mon Nov 03, 2008 9:07 am
Location: Philadelphia, PA USA
Model of CNC Machine: Camaster Cobra

Re: Strange result with aspire 9.1

Postby sawmiller » Fri Oct 13, 2017 4:36 pm

Setup is at top of material block, was just hilighting the soaring eagle
woodmizer sawmill and joe's hybrid cnc, a good combination
In the heart of Tn
User avatar
sawmiller
Vectric Wizard
 
Posts: 428
Joined: Sat May 03, 2008 8:34 pm
Location: camden,tn
Model of CNC Machine: joe's rack and pinion hybrid

Re: Strange result with aspire 9.1

Postby sawmiller » Fri Oct 13, 2017 4:44 pm

I'll figure it out, helping a guy move right now.
Thanks for the input
woodmizer sawmill and joe's hybrid cnc, a good combination
In the heart of Tn
User avatar
sawmiller
Vectric Wizard
 
Posts: 428
Joined: Sat May 03, 2008 8:34 pm
Location: camden,tn
Model of CNC Machine: joe's rack and pinion hybrid


Return to Aspire - General

Who is online

Users browsing this forum: Craig Thompson and 14 guests