Decided to make a mantel, haven't been using 3d.
So I grabbed the soaring eagle in a handcarved recess
And selected it, chose model boundary, and it used the whole face of the mantel..
So I clicked model outline and selected that and finish model, and it dropped down. 39 before carving out the model...
It works as expected in aspire 8.5, so is this a bug?
Haven't tried other models yet, but I'll get back to it later today
Dan
Strange result with aspire 9.1
- sawmiller
- Vectric Wizard
- Posts: 531
- Joined: Sat May 03, 2008 8:34 pm
- Model of CNC Machine: joe's rack and pinion hybrid
- Location: camden,tn
Strange result with aspire 9.1
woodmizer sawmill and joe's hybrid cnc, a good combination
In the heart of Tn
In the heart of Tn
- mezalick
- Vectric Wizard
- Posts: 2970
- Joined: Mon Nov 03, 2008 9:07 am
- Model of CNC Machine: Camaster Cobra
- Location: Philadelphia, PA USA
- Contact:
Re: Strange result with aspire 9.1
So, Maybe the mantel was the entire model ???
Next item of selecting just the vector could be that the "model" was positioned .39 below the top surface of the material block ???
Check in the Material Setup at the top right of the Toolpath screen...or as I call it "The Rigth Side ".
Michael
Next item of selecting just the vector could be that the "model" was positioned .39 below the top surface of the material block ???
Check in the Material Setup at the top right of the Toolpath screen...or as I call it "The Rigth Side ".
Michael
Michael Mezalick
https://www.youtube.com/user/mezalick
mm@mezalick.com
https://www.youtube.com/user/mezalick
mm@mezalick.com
- sawmiller
- Vectric Wizard
- Posts: 531
- Joined: Sat May 03, 2008 8:34 pm
- Model of CNC Machine: joe's rack and pinion hybrid
- Location: camden,tn
Re: Strange result with aspire 9.1
Setup is at top of material block, was just hilighting the soaring eagle
woodmizer sawmill and joe's hybrid cnc, a good combination
In the heart of Tn
In the heart of Tn
- sawmiller
- Vectric Wizard
- Posts: 531
- Joined: Sat May 03, 2008 8:34 pm
- Model of CNC Machine: joe's rack and pinion hybrid
- Location: camden,tn
Re: Strange result with aspire 9.1
I'll figure it out, helping a guy move right now.
Thanks for the input
Thanks for the input
woodmizer sawmill and joe's hybrid cnc, a good combination
In the heart of Tn
In the heart of Tn