I have an issue with my post I need my post to put out a feed rate on each line and I cannot figure out how to tell post processor to do this. I'm running Mach 3 I'm not sure if there is a setting in mach3 which will enable this to work or not any help on this would be great thanks.
What I'm looking to do is in my posted G-Code I need there to be a feed value on each G1 line. What's happening now is the very first G1 line it puts out a feed value but every other G1 line there is no feed value, so in mach3 when Irun a file once it gets to a G1 line without a feed value mach3 just sits & does nothing.
In my other cam systems there is a feed rate on each line of code and mach3 runs as expected.