The Job Setup Sheet is a great tool to use as it gives you all (almost) the data you need to go from your design to machining.
A useful improvement on the Setup Sheet would be to add the factors that are used for the time estimates, namely the Rapid Rate and the Scale Factor. In order to utilize the Time Estimates for any beneficial purpose, like cost estimation, the se two factos must be adjusted for the type of cuts you are making. You have to go through an iterative process to get the predicted Time Estimate to be close to the actual Time Estimate by adjusting the Scale Factor.
Having the Scale Factor on a hard copy of the Setup Sheet would greatly assist in this iteration process. Yes, I can and do, just write the information down when generating my toolpaths, but since the very useful Setup Sheet exists it would be helpful if the Scale Factor could be output with all the other information.
Has anyone figured out a way to edit the Setup Sheet and add this or other information that they desired?