help and suggestions

This forum is for general discussion about Aspire
Post Reply
gary n.
Posts: 25
Joined: Tue Aug 22, 2006 6:22 pm

help and suggestions

Post by gary n. »

The attached file will be a wedding gift on a cutting board--designed in Aspire 3.5. "ROEBUCK" is intended to appear as a phantom in a dish recess. Everything else will be v-carved. Would appreciate any suggestions for improvement in design etc. The phantom may need to be taller
Attachments
julie n dalton.crv3d
(1.69 MiB) Downloaded 110 times

User avatar
Mike-S
Vectric Wizard
Posts: 1123
Joined: Mon Jun 13, 2011 6:45 am
Model of CNC Machine: Joe's Hybrid 4x4 (but 3x3)
Location: Hayesville, NC

Re: help and suggestions

Post by Mike-S »

I'd make the date smaller.
Attachments
julie2.jpg

User avatar
highpockets
Vectric Wizard
Posts: 3667
Joined: Tue Jan 06, 2015 4:04 pm
Model of CNC Machine: PDJ Pilot Pro

Re: help and suggestions

Post by highpockets »

You might also use the smooth tool on the last name to round over the edges just a bit.
Image 20.png
or this
Image 21.png
John
Maker of Chips

Post Reply