First Attempt with the Diamond Drag Bit

This forum is for general discussion about Aspire

First Attempt with the Diamond Drag Bit

Postby Warped Mind » Mon Sep 18, 2017 2:51 pm

Ok, here is my first attempt with the diamond drag bit. I made a few adjustments that I think will make the next project much better. Increased the spring pressure in the bit and will decrease the stepover. Overall I am pretty satisfied with the results.
Attachments
mcconnells drag bit2.jpg
mcconnells drag bit.jpg
Warped Mind
Vectric Craftsman
 
Posts: 185
Joined: Thu Nov 21, 2013 9:10 pm
Location: York, SC
Model of CNC Machine: Laguna IQ

Re: First Attempt with the Diamond Drag Bit

Postby ohiolyons » Mon Sep 18, 2017 3:31 pm

thanks for sharing

Is there any prep you have to do to the stone? Some type of lubricant?
John
CNC in Kettering, Ohio
ohiolyons
Vectric Craftsman
 
Posts: 198
Joined: Wed May 27, 2009 7:16 pm
Location: Kettering, Ohio
Model of CNC Machine: Laguna IQ HHC, 3HP

Re: First Attempt with the Diamond Drag Bit

Postby Warped Mind » Mon Sep 18, 2017 3:33 pm

I did not add any coolant, but since I finished this one I have seen online where some people have added water to the surface.
Warped Mind
Vectric Craftsman
 
Posts: 185
Joined: Thu Nov 21, 2013 9:10 pm
Location: York, SC
Model of CNC Machine: Laguna IQ


Return to Aspire - General

Who is online

Users browsing this forum: No registered users and 17 guests