Pinning Toolpaths Pane Open

This forum is for general discussion about Aspire
Post Reply
AlbertaClipper
Vectric Apprentice
Posts: 91
Joined: Wed Dec 28, 2011 2:47 am
Model of CNC Machine: Home Built
Location: Lloydminster, Alberta, Canada

Pinning Toolpaths Pane Open

Post by AlbertaClipper »

Is there a way to pin the Toolpaths pane open so when a file is opened it is already pinned like the Drawing pane is pinned open?

User avatar
Adrian
Vectric Archimage
Posts: 14544
Joined: Thu Nov 23, 2006 2:19 pm
Model of CNC Machine: ShopBot PRS Alpha 96x48
Location: Surrey, UK

Re: Pinning Toolpaths Pane Open

Post by Adrian »

Yes, it's the same as the drawing toolpath. There is a pin on the top right which will lock it open. Make sure you set the relevant options under Edit/Options to save layouts or you'll have to do it every time. The defaults are only saved if you open Aspire directly rather than via a file as well.

AlbertaClipper
Vectric Apprentice
Posts: 91
Joined: Wed Dec 28, 2011 2:47 am
Model of CNC Machine: Home Built
Location: Lloydminster, Alberta, Canada

Re: Pinning Toolpaths Pane Open

Post by AlbertaClipper »

Adrian wrote: Make sure you set the relevant options under Edit/Options to save layouts or you'll have to do it every time. The defaults are only saved if you open Aspire directly rather than via a file as well.
Thanks, Adrian. You da Man!

User avatar
Martin Reid
Vectric Apprentice
Posts: 93
Joined: Wed May 18, 2016 6:00 pm
Model of CNC Machine: Shopbot
Location: Lancashire UK
Contact:

Re: Pinning Toolpaths Pane Open

Post by Martin Reid »

You can 'float' both the 'panes' if you have the room on the screen.

Pin open then drag the 'bar' handle.
Drag Floating
Drag Floating
Sincerely Martin

Post Reply