Pinning Toolpaths Pane Open
-
- Vectric Apprentice
- Posts: 91
- Joined: Wed Dec 28, 2011 2:47 am
- Model of CNC Machine: Home Built
- Location: Lloydminster, Alberta, Canada
Pinning Toolpaths Pane Open
Is there a way to pin the Toolpaths pane open so when a file is opened it is already pinned like the Drawing pane is pinned open?
- Adrian
- Vectric Archimage
- Posts: 14683
- Joined: Thu Nov 23, 2006 2:19 pm
- Model of CNC Machine: ShopBot PRS Alpha 96x48
- Location: Surrey, UK
Re: Pinning Toolpaths Pane Open
Yes, it's the same as the drawing toolpath. There is a pin on the top right which will lock it open. Make sure you set the relevant options under Edit/Options to save layouts or you'll have to do it every time. The defaults are only saved if you open Aspire directly rather than via a file as well.
-
- Vectric Apprentice
- Posts: 91
- Joined: Wed Dec 28, 2011 2:47 am
- Model of CNC Machine: Home Built
- Location: Lloydminster, Alberta, Canada
Re: Pinning Toolpaths Pane Open
Thanks, Adrian. You da Man!Adrian wrote: Make sure you set the relevant options under Edit/Options to save layouts or you'll have to do it every time. The defaults are only saved if you open Aspire directly rather than via a file as well.
- Martin Reid
- Vectric Apprentice
- Posts: 93
- Joined: Wed May 18, 2016 6:00 pm
- Model of CNC Machine: Shopbot
- Location: Lancashire UK
- Contact:
Re: Pinning Toolpaths Pane Open
You can 'float' both the 'panes' if you have the room on the screen.
Pin open then drag the 'bar' handle.
Sincerely Martin
Pin open then drag the 'bar' handle.
Sincerely Martin