postprocessor location

This forum is for general discussion about Aspire
Post Reply
advent111
Posts: 11
Joined: Sat Jul 23, 2011 11:55 pm
Model of CNC Machine: Shark Pro

postprocessor location

Post by advent111 »

I have forgotten where the postprocessors are located, the documentation in the postprocessor section is not clear, can anyone help

User avatar
martin54
Vectric Archimage
Posts: 7332
Joined: Fri Nov 09, 2012 2:12 pm
Model of CNC Machine: Gerber 48, Triac PC, Isel fixed gantry
Location: Kirkcaldy, Scotland

Re: postprocessor location

Post by martin54 »

not got the software on this computer but they are either in users/public/public documents or program data/vectric not sure but thought you could access them through the application data drop down in the software

User avatar
Rcnewcomb
Vectric Archimage
Posts: 5864
Joined: Fri Nov 04, 2005 5:54 am
Model of CNC Machine: 24x36 GCnC/WinCNC with ATC
Location: San Jose, California, USA
Contact:

Re: postprocessor location

Post by Rcnewcomb »

FOADF.png
PostProcessorFolders.PNG
- Randall Newcomb
10 fingers in, 10 fingers out, another good day in the shop

advent111
Posts: 11
Joined: Sat Jul 23, 2011 11:55 pm
Model of CNC Machine: Shark Pro

Re: postprocessor location

Post by advent111 »

Thank You, with your help I found what I was looking for

Post Reply