Control toolpath order of cut using same tool

This forum is for general discussion about Aspire
Post Reply
rwebcon
Vectric Apprentice
Posts: 88
Joined: Mon Jan 18, 2016 8:55 pm
Model of CNC Machine: Axiom Elite 4 X 4

Control toolpath order of cut using same tool

Post by rwebcon »

I have three tool paths all using the same tool .25 End Mill, but I want to run the profile toolpath last. How do I save all three in one file and have them run in the order I choose, profile part last. Is this possible or do I need to save the profile in a separate file and run it last?

User avatar
highpockets
Vectric Wizard
Posts: 3667
Joined: Tue Jan 06, 2015 4:04 pm
Model of CNC Machine: PDJ Pilot Pro

Re: Control toolpath order of cut using same tool

Post by highpockets »

The order you have them in the Toolpath list should be the order they are generated in the Post Processor. I've heard of some people having trouble with the order, but I'm running Mach3 and never had an issue doing this way.
John
Maker of Chips

4DThinker
Vectric Wizard
Posts: 1701
Joined: Sun Sep 23, 2012 12:14 pm
Model of CNC Machine: CNC Shark Pro, Probotix Meteor 25" x 50"

Re: Control toolpath order of cut using same tool

Post by 4DThinker »

In the toolpath list there are arrows to help you move each toolpath up or down until you are happy with how they are listed. Then save them all as once file.

There are some machine controllers out there that will try and optimize the g-code for efficiency of movement. If you see that they are not cutting in the order you saved them you may need to look into your controller options to turn off such optimization.

Post Reply