This forum is for general discussion about Aspire
Ok.. Anyone else bugged by the job sheet icon replacing the position of the save toolpath icon's spot in V9?
I assume I'll have to get adjusted to this as not likely to move but doing so does cause some mental pain.
Also would love if you would adopt the standard for Yes, No Cancel dialog to enable Y, N key presses as input. but that is an entirely different nitpick of the gui for me.
- Vectric Wizard
- Posts: 341
- Joined: Sun Nov 19, 2006 2:20 am
- Location: Michigan
Return to Aspire - General
Who is online
Users browsing this forum: No registered users and 23 guests