Tarbernacle Table or Chalice.

This forum is for general discussion about Aspire

Tarbernacle Table or Chalice.

Postby Jane Ndungu » Fri Aug 04, 2017 9:03 pm

Hello Vectric family,
I hope that you are all doing fine. Kindly seeking for a source where i can get Tabernacle Table or Chalice for CNC engraving.

Any help is Most appreciated in advance.

Kind regards
Jane
Jane Ndungu
Vectric Craftsman
 
Posts: 188
Joined: Fri Oct 31, 2014 8:14 am
Model of CNC Machine: TS1325

Re: Tarbernacle Table or Chalice.

Postby Mike-S » Sat Aug 05, 2017 12:37 am

You can make your own Chalice with the new Turn & Spin feature.
User avatar
Mike-S
Vectric Wizard
 
Posts: 953
Joined: Mon Jun 13, 2011 6:45 am
Location: Hayesville, NC
Model of CNC Machine: Joe's Hybrid 4x4 (but 3x3)

Re: Tarbernacle Table or Chalice.

Postby Jane Ndungu » Sat Aug 05, 2017 6:32 am

Mike-S wrote:You can make your own Chalice with the new Turn & Spin feature.


Good morning Mike,
Thanks for the reply, kindly i must confess that i have no idea about Turn & Spin feature. is it in the new version 9?

I would appreciate if you could tell me more about this.
Thanks

Kind regards
Jane
Jane Ndungu
Vectric Craftsman
 
Posts: 188
Joined: Fri Oct 31, 2014 8:14 am
Model of CNC Machine: TS1325

Re: Tarbernacle Table or Chalice.

Postby mezalick » Sat Aug 05, 2017 4:15 pm

Michael Mezalick
https://carveddetails.com/catalog-book/
mm@mezalick.com
User avatar
mezalick
Vectric Wizard
 
Posts: 2225
Joined: Mon Nov 03, 2008 9:07 am
Location: Philadelphia, PA USA
Model of CNC Machine: Camaster Cobra

Re: Tarbernacle Table or Chalice.

Postby Jane Ndungu » Mon Aug 07, 2017 3:40 pm

mezalick wrote:Jane,
Take a look at this
http://support.vectric.com/tutorials/V9 ... ideo_id=97

Michael



Thanks Michael
Jane Ndungu
Vectric Craftsman
 
Posts: 188
Joined: Fri Oct 31, 2014 8:14 am
Model of CNC Machine: TS1325


Return to Aspire - General

Who is online

Users browsing this forum: No registered users and 15 guests