This forum is for general discussion about Aspire
Thank you everyone with your help with my problem. I think the problem was in my Stepper motor acceleration settings. All of my axis had very low acceleration settings (2) Was able to increase my Z axis acceleration to 15 (from 2) and was able to change my X and Y from 2 to 8. While still having motors run smoothly. I ran the same exact gcode and was able to run the same gcode an hour faster than the previous run with minimal toolmarks. (See Photos) I will continue to fine tune. I'm surprised I was able to complete any of the previous projects with poorly tuned stepper motors.
Again thank you all for the trouble shooting.
- Posts: 7
- Joined: Mon Jul 02, 2012 11:56 pm
- Model of CNC Machine: Geometric Robotics 2x4 commercial kit
Happy to hear you have solved the problem!
I would have bet dollars to donuts that you had something loose. So much for my being an "expert" huh?
Low Profile CNC Router Vise
- Vectric Wizard
- Posts: 2047
- Joined: Thu Jan 18, 2007 6:04 pm
- Location: Leland NC
- Model of CNC Machine: 8020 Build 48X36X8 RP 2010 Screenset
Return to Aspire - General
Who is online
Users browsing this forum: No registered users and 14 guests