Two Rail Sweep to create a frame
-
- Vectric Apprentice
- Posts: 92
- Joined: Mon Jan 18, 2016 8:55 pm
- Model of CNC Machine: Axiom Elite 4 X 4
Two Rail Sweep to create a frame
I have material 11” by 11” with an inlay. I want to cut a frame outline around the inlay to make it look like its mount in a frame. I can create the frame but the frame always slants towards the inside leaving a pocket around the inlay. I want to reverse the angle of the frame so that what was the outer edge is now the inter edge. Is this possible?
- dealguy11
- Vectric Wizard
- Posts: 2493
- Joined: Tue Sep 22, 2009 9:52 pm
- Model of CNC Machine: Anderson Selexx 510,24x48 GCnC/WinCNC
- Location: Henryville, PA
Re: Two Rail Sweep to create a frame
Mirror the sweep vector before you create the 2-rail sweep to flip it left to right.
Steve Godding
Not all who wander (or wonder) are lost
Not all who wander (or wonder) are lost
- Leo
- Vectric Wizard
- Posts: 4091
- Joined: Sat Jul 14, 2007 3:02 am
- Model of CNC Machine: 1300 x 1300 x 254 Chinese Made
- Location: East Freetown, Ma.
- Contact:
Re: Two Rail Sweep to create a frame
Yes it is possible.
I did a frame a couple of years ago much the same.
Its all about the order of vector selection.
I don't remember exactly what I did, but there will be a specific order of selection
Inside first then outside or visa versa
I did a frame a couple of years ago much the same.
Its all about the order of vector selection.
I don't remember exactly what I did, but there will be a specific order of selection
Inside first then outside or visa versa
Imagine the Possibilities of a Creative mind, combined with the functionality of CNC
-
- Vectric Apprentice
- Posts: 92
- Joined: Mon Jan 18, 2016 8:55 pm
- Model of CNC Machine: Axiom Elite 4 X 4
Re: Two Rail Sweep to create a frame
Thanks, it worked with a little change here and their....
- jimwill2
- Vectric Wizard
- Posts: 612
- Joined: Tue Aug 31, 2010 1:48 am
- Model of CNC Machine: CaMaster Stinger w/recoil, FTC
- Location: Parkville, Missouri
Re: Two Rail Sweep to create a frame
If you have Aspire 8.5 you can save lots of cutting time by using the 'moulding toolpath.' It makes great frames and cuts much faster than 3D frame toolpath. Check out the tutorial: http://support.vectric.com/tutorials/V8 ... 25DTP.html
Jim Williams
-
- Vectric Apprentice
- Posts: 92
- Joined: Mon Jan 18, 2016 8:55 pm
- Model of CNC Machine: Axiom Elite 4 X 4
Re: Two Rail Sweep to create a frame
Thanks for the tip, I will give it a try. There are some many features in the software it hard to keep up with them all...