Any High School Teachers out there using Aspire
-
- Posts: 23
- Joined: Tue Apr 08, 2014 7:04 pm
- Model of CNC Machine: Multicam, torchmate , maxnc, DIY MACH3
- Location: Marysville, WA
- Contact:
Any High School Teachers out there using Aspire
Looking for all the High School teachers using Aspire. It's such a great part of my program and I am looking to create a group. I think that this is a small group of people that could easily share support for lessons and ideas.
- martin54
- Vectric Archimage
- Posts: 7339
- Joined: Fri Nov 09, 2012 2:12 pm
- Model of CNC Machine: Gerber 48, Triac PC, Isel fixed gantry
- Location: Kirkcaldy, Scotland
Re: Any High School Teachers out there using Aspire
There are at least a couple of guys on the forum that teach but not sure if it is High School
-
- Posts: 23
- Joined: Tue Apr 08, 2014 7:04 pm
- Model of CNC Machine: Multicam, torchmate , maxnc, DIY MACH3
- Location: Marysville, WA
- Contact:
Re: Any High School Teachers out there using Aspire
I guess, yeah, that may have been too specific. Any teaching of Aspire or Vectric at all is all helpful to each other. I haven't seen a lot of middle school interest in CNC as I have been a shop teacher, so I was making a major assumption. Also, colleges are usually a highly different enterprise in interest and focus. I am looking to develop and share lessons for students that have little to no prior experience in anything shop related. We have done pretty well over the last 6 years with Aspire and looking to develop a community of teacher users.
- Rcnewcomb
- Vectric Archimage
- Posts: 5886
- Joined: Fri Nov 04, 2005 5:54 am
- Model of CNC Machine: 24x36 GCnC/WinCNC with ATC
- Location: San Jose, California, USA
- Contact:
Re: Any High School Teachers out there using Aspire
You may find some at the ShopBot in Schools forum.
- Randall Newcomb
10 fingers in, 10 fingers out, another good day in the shop
10 fingers in, 10 fingers out, another good day in the shop