Tile tool path inlay help

This forum is for general discussion about Aspire

Tile tool path inlay help

Postby Larry Cessna » Thu Mar 10, 2016 10:47 pm

I would like to cut these inlay pockets so they are not split in a tile. The design is 50x32 my cnc will cut 48x48 so I will need to tile the design. The question is how can I do this so I do not have a pocket split in a tile. Or put it this way. When I tile a design and move the board down using peg holes is it still off about a 1/16 or so. This is fine for most things but not for an inlay. Is there a way to cut this so the entire pocket for the inly is cut in a tile. Can I cut the over lap in one tile and not the other.
Attachments
topp3.jpg
Larry Cessna
Vectric Craftsman
 
Posts: 123
Joined: Wed Feb 12, 2014 3:52 pm
Model of CNC Machine: Laquna Swift

Return to Aspire - General

Who is online

Users browsing this forum: No registered users and 18 guests