converting 3d model for v-carving

This forum is for general discussion about Aspire
Post Reply
Warped Mind
Vectric Craftsman
Posts: 214
Joined: Thu Nov 21, 2013 9:10 pm
Model of CNC Machine: Laguna IQ
Location: York, SC

converting 3d model for v-carving

Post by Warped Mind »

can anyone tell me if you can convert the 3d clipart for v carving, specifically the flourishes.

Thanks
Top
User avatar
mezalick
Vectric Wizard
Posts: 2982
Joined: Mon Nov 03, 2008 9:07 am
Model of CNC Machine: Camaster Cobra
Location: Philadelphia, PA USA
Contact:
Contact mezalick

Re: converting 3d model for v-carving

Post by mezalick »

Yes you can.
Check the tutorial on this.

http://support.vectric.com/tutorials/V8 ... cks_6.html

Michael
Michael Mezalick
https://www.youtube.com/user/mezalick
mm@mezalick.com
Top
Warped Mind
Vectric Craftsman
Posts: 214
Joined: Thu Nov 21, 2013 9:10 pm
Model of CNC Machine: Laguna IQ
Location: York, SC

Re: converting 3d model for v-carving

Post by Warped Mind »

Thanks for the info.
Top
Post Reply

Return to “Aspire - General”