I'm trying to carve a birth plaque using vector arts rocking horse, the roughing tool path works fine just cuts out the horse but when I run the finish toolpath it cuts the entire project not just the rocking horse ( the horse turns out fine but it takes forever to surface the entire project.
thanks in advance
John
Finish toolpath
-
- Vectric Apprentice
- Posts: 68
- Joined: Tue Mar 02, 2010 10:46 pm
- Model of CNC Machine: Camaster Stinger Epilog Aspire
- Location: Austin TX
- Adrian
- Vectric Archimage
- Posts: 14656
- Joined: Thu Nov 23, 2006 2:19 pm
- Model of CNC Machine: ShopBot PRS Alpha 96x48
- Location: Surrey, UK
Re: Finish toolpath
Did you create a boundary vector? Use the create vector boundary tool to create it if you didn't. Make sure it's selected when you create the roughing/finishing toolpaths.
-
- Vectric Apprentice
- Posts: 68
- Joined: Tue Mar 02, 2010 10:46 pm
- Model of CNC Machine: Camaster Stinger Epilog Aspire
- Location: Austin TX
Re: Finish toolpath
Thanks, I knew that at one point and just forgot ( at this stage forgetting is so much easier than learning or remembering )
John
John