Some time ago I asked why the preview couldn't be visible after the Preview Form was closed and I was told it only could be done in VCP?????
I knew I had done it before but couldn't find the picture..
Well, here is the screenshot.
The preview form is closed and the cutting time form is open but the preview is still there and another one with the tool Form open.
HOW DID I DO IT?
I have no idea myself only that it IS possible to do it but why not every time?
Cheers
Wolffie
I knew I had done it before
- Ms Wolffie
- Vectric Wizard
- Posts: 2695
- Joined: Sat Mar 31, 2012 10:41 pm
- Model of CNC Machine: Blue Elephant 1325, Shark HD Pro
- Location: Tully Heads, Wet Tropics, Queensland, Australia
I knew I had done it before
Cheers
Wolffie
Whatshammacallit
Cut3D, VCarvePro 6.5, Aspire4, PhotoVCarve, Corel Graphics Suite X6
Wolffie
Whatshammacallit
Cut3D, VCarvePro 6.5, Aspire4, PhotoVCarve, Corel Graphics Suite X6
-
- Vectric Wizard
- Posts: 4797
- Joined: Thu May 18, 2006 3:24 pm
- Model of CNC Machine: ShopBot
- Location: North Carolina
Re: I KNEW I had done it before
Your pictures show the 3D Modeling view, not the toolpath preview, and the component shown is your 3D model and not the results of running your two toolpaths, a 3D Roughing and Profile. You can tell by observing the Modeling Plane sitting under the model.
Adrian's answer to you in your other post still applies.
Tim
Adrian's answer to you in your other post still applies.
Tim
- Ms Wolffie
- Vectric Wizard
- Posts: 2695
- Joined: Sat Mar 31, 2012 10:41 pm
- Model of CNC Machine: Blue Elephant 1325, Shark HD Pro
- Location: Tully Heads, Wet Tropics, Queensland, Australia
Re: I KNEW I had done it before
Yes, after mucking around with it for a while, I realised the vectors weren't there only the 3D model
Cheers
Wolffie
Cheers
Wolffie
Cheers
Wolffie
Whatshammacallit
Cut3D, VCarvePro 6.5, Aspire4, PhotoVCarve, Corel Graphics Suite X6
Wolffie
Whatshammacallit
Cut3D, VCarvePro 6.5, Aspire4, PhotoVCarve, Corel Graphics Suite X6