This forum is for general discussion about Aspire
Not sure how to properly make multiple finishing tool paths.
I want all of the finishing to be nice and smooth which is why the big area I was doing the finishing with a 0.25 inch ball nose bit. But the neck pocket I want to have very sharp corners at the bottom.
How do I make just the neck pocket finished with a 0.25 end mill and the rest finished with a ball nose?
When I use the vector boundary button it does not create vectors for the neck pocket.
- Vectric Wizard
- Posts: 473
- Joined: Tue Sep 04, 2007 11:45 am
- Location: Maryland, USA
- Model of CNC Machine: DIY
I think you need to use the 3d finish pass for everything but the pockets, and then use a separate pocket toolpath for the neck and pickups....you may need to draw a vector for the neck pocket by itself....
" I'm tryin to think but nothin happens " - Curly Howard
- Vectric Craftsman
- Posts: 204
- Joined: Thu Jan 08, 2009 4:35 pm
- Location: Willowick, Ohio USA
- Model of CNC Machine: Homebuilt 3'x5'x6"
Return to Aspire - General
Who is online
Users browsing this forum: Bing [Bot], fixtureman, Google [Bot], Yahoo [Bot] and 8 guests