I am new to hobby, I notice most of the carving is done with v bits, 60 or 90 deg. by 1.25, I am using a portercable trim router that takes 1/4 bits, I have not seen a v bit in the above size with 1/4 shank. Am I just looking in the wrong places?
Thanks.
question on bits
They make them with 1/4" shanks. I have a few. The only one I can read the name on is a Bosch #85220M. Be warned that this one does not have a "true point". In other words, it does not go to a sharp V. It has a 1/16" flat across the bottom. Sears sells them for sure.
Jason
Jason
The Official Vectric Cartographer
You are limited only by your imagination
You are limited only by your imagination
- dighsx
- Vectric Wizard
- Posts: 939
- Joined: Tue Nov 01, 2005 12:36 am
- Location: Royal Oak, Michigan USA
- Contact:
Hey Shaka check out this thread for some suppliers of bits: http://vectric.com/forum/viewtopic.php? ... t=supplier
You should be able to find the bits your looking for in that thread.
You should be able to find the bits your looking for in that thread.
Take it easy.
Jay (www.cncjay.com)
Jay (www.cncjay.com)