Shark Owners What did I miss Solution

[MountainAngler]

I recently posted "What did I miss"..so what was happening...I would load a new toolpath click "run from sd card " and the router would go up..., then down and complete. I thought it was my toolpath...not calculated correctly...after some time of reworking my new toolpath...I loaded a toolpath I had used previously with good results, same result, z axix up...down, program complete. I then contacted Next Wave Automation via e-mail after a few mail exchanges each way( over 2 days) I was directed to their download page...where I downloaded their new control panel (took a couple of hours ) and am now actively machineing...the interface with the new control panel is a little different...anyways all I can say "glad to back in sawdust again", and hope this saves someone some time and frustration.

Charlie