I am using a slower older machine and everytime z goes up it goes .7840.
How do I change this to be just .25?
I saw a section in the help file under materail setup but I did not have the option for the z home.
Thanks
Z home position
- Paco
- Vectric Wizard
- Posts: 480
- Joined: Fri Sep 16, 2005 6:30 pm
- Location: Valcourt, Québec, Canada
- Contact:
It's there; toolpath menu (right pannel one; not the Edit menu one; the toolpath menu one relate with the real life [toolpath] material settings while the Edit menu one relate to the drawing mode [2D]), material setup. Set the Z home according to your needs... even the X & Y can be set some where else than 0,0; you don't necessarily need to have the tool back over your part once done.
Does that make sense?
Does that make sense?
-
- Posts: 10
- Joined: Wed Aug 09, 2006 12:02 am
Got it thanks.Paco wrote:It's there; toolpath menu (right pannel one; not the Edit menu one; the toolpath menu one relate with the real life [toolpath] material settings while the Edit menu one relate to the drawing mode [2D]), material setup. Set the Z home according to your needs... even the X & Y can be set some where else than 0,0; you don't necessarily need to have the tool back over your part once done.
Does that make sense?