been trying to open the enclosed file with vcarve 8.5 but no luck
tried with two computers same results.
after i open the zip file i then import the dxf file into vcarve but computers just lock up.
anyone know why?
Paul
opening file problem
opening file problem
- Attachments
-
- Dollhouse4floors (5).zip
- (863.92 KiB) Downloaded 50 times
- Adrian
- Vectric Archimage
- Posts: 14660
- Joined: Thu Nov 23, 2006 2:19 pm
- Model of CNC Machine: ShopBot PRS Alpha 96x48
- Location: Surrey, UK
Re: opening file problem
Imports for me in the older versions but it's very sluggish due to the number of nodes in the drawings. Depending on the speed of your PC it might look like it's locked up.
-
- Vectric Wizard
- Posts: 520
- Joined: Sun May 03, 2015 12:25 pm
- Model of CNC Machine: Axiom AR8
- Location: Savannah, GA
Re: opening file problem
Adrian's right. It takes some time for it to load in dxf format. I opened the cdr file in Inkscape and saved as svg and pdf formats and both of those loaded much quicker. Lots of nodes. You could probably spend quite a bit of time fixing them but not sure it's worth it. I didn't try to do any toolpaths on it. Good luck.
Re: opening file problem
Thanks everyone i never thought on nodes. yes i dont think its worth it.