jaru-eri wrote:I have now seen that there already was calculated two toolpats for this file, but the final result when I previewed this toolpats went out like this:The final picture didn´t show as a rotating job, but as it was a single side job.
I'll need to look deeper into this but here's my version..
It works as expected.
jaru-eri wrote:Do you think you can save this file in a way which also can be opened in Vcarve?
4DThinker wrote:The flat view looks correct. It is when I turn on the 3D view of a rotary job that I get the flawed render as above. I've even switch axes and tried again but still get a flawed 3D render.
Users browsing this forum: No registered users and 46 guests