shelkol wrote:I'd upload the file, but I've limited it to a rather small section. It is the last line below that causes it to go too deep.
shelkol wrote:More info:
It is not a vcarve issue.
I was trying to rout one side of aluminum angle, so I put it on a 2x4 on top of my waste board. When working at the higher elevations, it starts too deep into the material. Just for an attempt, I tried the same exact gcode on just a peice of 3/4" pine and it worked fine. So I'm inquiring with carbide motion people to see if they think I'm crazy ( I can answer that question - 'YES' )
Thanks for all your input
Now all I have to figure out is how to get Vcarve not to raise the Z axis so high during setting up the cut.
Users browsing this forum: No registered users and 35 guests