Tiles sizes

This forum is for general discussion regarding VCarve Pro
Post Reply
hanks
Posts: 3
Joined: Sun Jun 24, 2018 4:38 pm
Model of CNC Machine: Shark Slimline

Tiles sizes

Post by hanks »

Is it possible to make tiles different sizes? ie.. 7.25 x 17.25 and 7.25 x 19

User avatar
jfederer
Vectric Wizard
Posts: 364
Joined: Tue Nov 27, 2018 1:09 am
Model of CNC Machine: CanCam D23M
Location: Horton Township Ontario Canada
Contact:

Re: Tiles sizes

Post by jfederer »

I don't think so. You have 3 options: Tile in X, Y, or Individual Tiles. Only the last of these (it actually is first on the selection list) allows both dimensions to be specified. All tiles will then be those dimensions.

However, if you choose either of the X or Y feed-throuh options, you can make the tile size an arbitrary size that is less than your machine bed, but one which will extend the last tile over the end of the bed. This would have the effect of making the last tile smaller than the others. I suppose the same would be true for the Individual Tiles option, but I haven't tried that.
Joe Federer

www.fabrikisto.com incl. Tailmaker software
www.federer.ca

Post Reply