Postprocessor for LinuxCNC
Postprocessor for LinuxCNC
Is there a postprocessor for linuxCNC that will allow Gcode to run a full project and allow tool changes? I currently have to load each tool code separately. Thanks
- Rcnewcomb
- Vectric Archimage
- Posts: 5915
- Joined: Fri Nov 04, 2005 5:54 am
- Model of CNC Machine: 24x36 GCnC/WinCNC with ATC
- Location: San Jose, California, USA
- Contact:
Re: Postprocessor for LinuxCNC
You might start with GCode_ATC_inch.PP or GCode_ATC_mm.PP
- Randall Newcomb
10 fingers in, 10 fingers out, another good day in the shop
10 fingers in, 10 fingers out, another good day in the shop