Driving a Gerber Sabre?
-
- Posts: 2
- Joined: Tue Feb 19, 2019 3:11 am
- Model of CNC Machine: Gerber Sabre 404
Driving a Gerber Sabre?
New to the forum. Any thoughts regarding Vectric VCarve or Aspire compatiblity to run an older Gerber Sabre. I understand that the Gerber was originally designed to be operated with their proprietary software (Artpath / Autocarve). I noticed that Enroute lists Gerber as a supported machine, not sure about Vectric. Thanks!!
- Adrian
- Vectric Archimage
- Posts: 14680
- Joined: Thu Nov 23, 2006 2:19 pm
- Model of CNC Machine: ShopBot PRS Alpha 96x48
- Location: Surrey, UK
Re: Driving a Gerber Sabre?
There are lots of threads on here about it. If you type Gerber into the search box at the top of the page you'll find them. It doesn't look like it's a very straightforward thing to do going by the couple of posts I read.
-
- Posts: 2
- Joined: Tue Feb 19, 2019 3:11 am
- Model of CNC Machine: Gerber Sabre 404
Re: Driving a Gerber Sabre?
It doesn't look like anyone has discussed it in a while.