On the Fly Font Install Like CorelDraw

[HMPrintDesign]

Hello,

I hope a moderator can follow this.

I have over 3000 fonts and obviously cannot load all these at startup. Corel allows on the fly use of fonts whether they are installed or not. It would be so beneficial if V-Carve Pro could also utilize this ability. I would appreciate if this could be implemented in the next update or release as it would save many extra steps of creating in Corel only to export a font then import into V-Carve.

-Wayne Hesler-Mondore
Monticello Mercantile

[Adrian]

I asked for this myself a few years ago as well.

It would be great to have this facility as I have many fonts that are only suitable for vinyl cutting, others that are only suitable for web design and others that are only any good for 3D printing but VCarve/Aspire loads them all. I'd like to be able to specify a list of fonts to ignore/load ideally.

You need to send the request to support@vectric.com so it's correctly logged as this is primarily a user to user forum and not all posts are necessarily seen by Vectric staff.