VCarve Pro leaving a rib on my roatary job
-
- Posts: 3
- Joined: Thu May 17, 2018 9:19 pm
- Model of CNC Machine: Laguna Turner
VCarve Pro leaving a rib on my roatary job
Any idea why it is doing this? Ive changed nothing from the past jobs but it suddenly started not finishing the whole part.
- Rcnewcomb
- Vectric Archimage
- Posts: 5932
- Joined: Fri Nov 04, 2005 5:54 am
- Model of CNC Machine: 24x36 GCnC/WinCNC with ATC
- Location: San Jose, California, USA
- Contact:
Re: VCarve Pro leaving a rib on my roatary job
On the finish pass set the Boundary Offset to slightly over 1/2 of the bit diameter.
- Randall Newcomb
10 fingers in, 10 fingers out, another good day in the shop
10 fingers in, 10 fingers out, another good day in the shop
-
- Posts: 3
- Joined: Thu May 17, 2018 9:19 pm
- Model of CNC Machine: Laguna Turner
Re: VCarve Pro leaving a rib on my roatary job
Tried over 1/2 the diameter first, but the program then wanted to machine the ends of the part as well. Tried under 1/2 the diameter and it worked.
But why am I having to this now and never had to before? Any reasoning?
But why am I having to this now and never had to before? Any reasoning?