sharkcutup wrote:I always just add some vectors to the areas where I would like the machine to carve. And when doing this if it is a 3D model be sure to Select 'project tool path onto 3D model' or else you will be just cutting air. It take a little extra time but the end results are much better.
Just a Thought!
sharkcutup wrote:Hey Martin54,
I do understand that it is a 3D model being finished entirely.
You have a clever idea but I was just pointing out that there is another way to do some cleanup which has served well for me which is a separate toopath usually a profile toolpath and I was pointing out that if anyone was to do this on a 3D model to be sure to check the box "project toolpath onto 3D model"or else they would be just cutting air.
I was not in any way trying to take away from your initial post, In fact, I sort of like to try your idea next time.
Users browsing this forum: No registered users and 39 guests