I for the life of me just can't get this... what I want is a dish .5 inches deep into .75 material. The inside that a sunflower (3d) . I have tried for about 2 hours now.. either the dish is set into the board too far leaving an edge or the flower is above the z of the top of the material.
If someone could step this out for me I would appreciate it immensely.
Wayne
Putting a flower into a dish
- HMPrintDesign
- Posts: 16
- Joined: Fri Jul 08, 2016 10:04 pm
- Model of CNC Machine: X-Carve 1000
- Location: Richfield Springs, NY
- Contact:
Putting a flower into a dish
Thank you,
Stephen and Wayne Hesler-Mondore
HM Print and Design
hmprintdesign.com
Stephen and Wayne Hesler-Mondore
HM Print and Design
hmprintdesign.com
- Adrian
- Vectric Archimage
- Posts: 14544
- Joined: Thu Nov 23, 2006 2:19 pm
- Model of CNC Machine: ShopBot PRS Alpha 96x48
- Location: Surrey, UK
Re: Putting a flower into a dish
Have you watched this tutorial? http://support.vectric.com/tutorials/V9 ... ideo_id=64
The key is the multiply combine mode.
The key is the multiply combine mode.