Putting a flower into a dish

This forum is for general discussion regarding VCarve Pro

Putting a flower into a dish

Postby HMPrintDesign » Tue Oct 09, 2018 7:01 pm

I for the life of me just can't get this... what I want is a dish .5 inches deep into .75 material. The inside that a sunflower (3d) . I have tried for about 2 hours now.. either the dish is set into the board too far leaving an edge or the flower is above the z of the top of the material.

If someone could step this out for me I would appreciate it immensely.

Wayne :cry:
Posts: 4
Joined: Fri Jul 08, 2016 10:04 pm
Model of CNC Machine: X-Carve

Re: Putting a flower into a dish

Postby Adrian » Tue Oct 09, 2018 7:21 pm

Have you watched this tutorial? http://support.vectric.com/tutorials/V9 ... ideo_id=64

The key is the multiply combine mode.
User avatar
Vectric Archimage
Posts: 9214
Joined: Thu Nov 23, 2006 2:19 pm
Location: Surrey, UK
Model of CNC Machine: ShopBot PRS Alpha 96x48

Return to VCarve - General

Who is online

Users browsing this forum: No registered users and 35 guests