Hello,
I'm getting to grips with V-Carve wizard and cnc routing in general!
My first test cut has the tool scoring the top surface of the substrate - I notice in VCW the "Safe Z" is reading quite small 0.0394". How is this figure calculated, and is there a means to adjust it? Or if I'm on the wrong tack altogether, what should I be doing instead?
Any help appreciated!
Newbie questions!
Hello GVP,
In VCarve Wizard the Rapid Clearance Gap = SafeZ height.
This is specified on the Material Setup form which is the 1st icon on the Toolpath Tab as shown below.
Let us know if you need further assistance.
Tony
In VCarve Wizard the Rapid Clearance Gap = SafeZ height.
This is specified on the Material Setup form which is the 1st icon on the Toolpath Tab as shown below.
Let us know if you need further assistance.
Tony
- Attachments
-
- Form.jpg (13.39 KiB) Viewed 1145 times
-
- Setup_Material.jpg (8.34 KiB) Viewed 1455 times