Thanks for the help,
I also received a post from Vectric Support yesterday. They are working hard on getting it up and running for me.
We will try both posts today.
I will keep you updated on the results.
Thanks so much again for all the help.
Bill
Post Processor
-
- Posts: 9
- Joined: Thu Aug 02, 2018 10:31 pm
- Model of CNC Machine: CR Onsrud M-Series Model 145M12D
- dealguy11
- Vectric Wizard
- Posts: 2464
- Joined: Tue Sep 22, 2009 9:52 pm
- Model of CNC Machine: Anderson Selexx 510
- Location: Henryville, PA
Re: Post Processor
Here's what my Gcode reference says about G5.1 Q1:
Uses a deep look-ahead buffer and simulation processing to provide better axis movement acceleration and deceleration during contour milling
Uses a deep look-ahead buffer and simulation processing to provide better axis movement acceleration and deceleration during contour milling
Steve Godding
Not all who wander (or wonder) are lost
Not all who wander (or wonder) are lost
-
- Posts: 9
- Joined: Thu Aug 02, 2018 10:31 pm
- Model of CNC Machine: CR Onsrud M-Series Model 145M12D
Re: Post Processor
I want to thank all those who tried to help me with the Post Processor for my CNC machine. My sales rep of the CNC machine was able to work on the post processor for me and get it working with V Carve Pro. I am finally up and running. Cut out some counter tops today with sink cut outs and it worked perfect.
Thanks again,
Bill
Thanks again,
Bill
- Rcnewcomb
- Vectric Archimage
- Posts: 5887
- Joined: Fri Nov 04, 2005 5:54 am
- Model of CNC Machine: 24x36 GCnC/WinCNC with ATC
- Location: San Jose, California, USA
- Contact:
Re: Post Processor
Thanks for the follow up Bill.
- Randall Newcomb
10 fingers in, 10 fingers out, another good day in the shop
10 fingers in, 10 fingers out, another good day in the shop
Re: Post Processor SHARK HD4
I have a Shark HD4 and the proper processor for that is CNC Shark-USB Arcs (inch) *.tap and it works just fine.