Creating New Brush Tool

This forum is for general discussion regarding VCarve Pro

Creating New Brush Tool

Postby ger.wat » Thu Jul 05, 2018 10:45 pm

I need to create a Brush Tool for deburring. Since there's not a category/tool type for that I tried using End Mill but have found I can't set the speed anywhere near slow enough. I could if I were making a drill but then I couldn't use it on a traveling toolpath. Too many restrictions. How do I get around these restrictions to make a traveling tool that can run at 300 - 2000 rpm?

jerry
ger.wat
 
Posts: 10
Joined: Mon Oct 30, 2017 10:03 pm
Model of CNC Machine: ShopBot PRSAlpha

Re: Creating New Brush Tool

Postby martin54 » Thu Jul 05, 2018 11:55 pm

Not sure I follow what you are saying, what is stopping you setting the speed at what ever value you want ?

What are you using to cut ? A router or a spindle ? A high speed spindle probably won't start at such a low speed & even if it does it won't have enough torque to cut butter (warm butter at that ) :lol: :lol: :lol:
User avatar
martin54
Vectric Wizard
 
Posts: 3791
Joined: Fri Nov 09, 2012 2:12 pm
Location: Crossgates, Scotland
Model of CNC Machine: Gerber System 48 (modified)

Re: Creating New Brush Tool

Postby Adrian » Fri Jul 06, 2018 8:24 am

At what point are you not able to set the speed? VCarve will let you set the RPM to anything you like so I'm presuming it's an issue when you go to run the actual file which would be your control software not VCarve.
User avatar
Adrian
Vectric Archimage
 
Posts: 8226
Joined: Thu Nov 23, 2006 2:19 pm
Location: Surrey, UK
Model of CNC Machine: ShopBot PRS Alpha 96x48

Re: Creating New Brush Tool

Postby mtylerfl » Fri Jul 06, 2018 1:50 pm

ger.wat wrote:... How do I get around these restrictions to make a traveling tool that can run at 300 - 2000 rpm?

jerry


Do you have to override the ShopBot factory programming to get the spindle to run at those low rpm's? (If I recall, I think the lowest rpm I can set is 5K)
Michael Tyler

carvebuddy.com

facebook.com/carvebuddy

-CarveWright CNC
-ShopBot Buddy PRSAlpha CNC
User avatar
mtylerfl
Vectric Wizard
 
Posts: 3005
Joined: Thu Jan 29, 2009 3:54 am
Location: Brunswick, GA
Model of CNC Machine: -CarveWright CNC -ShopBot Buddy PRSAlpha


Return to VCarve - General

Who is online

Users browsing this forum: Mr.Chips and 18 guests